Before The First Use; Cleaning And Maintenance; Emptying The Dust Compartment - tomado TM-2420 Mode D'emploi

bEFORE THE FIRST uSE

• Take the appliance and accessories out the box.
Remove the stickers, protective foil or plastic from the
device.
• Place the hose with the side of the coupling in the
upper side of the vacuum cleaner, if you hear a click,
the tube is secured.
• Place the other side of the hose into the telescopic
tube.
• To disconnect the hose, press the button on the hose
coupling.
• Only use the device if all the filters included the dust
compartment are placed properly, a damaged or
improperly installed filter or dust compartment may
damage the unit.
uSE
• Use the on/off button to activate your device.
• Slide the telescopic tube to the desired length.
• Unwind a sufficient length of cable and insert the plug
into the power socket. The yellow mark on the power
cable shows the ideal cable length. Do not expend the
cable beyond the red mark.
• Use the button on the floor brush and choose the
desired position, with or without brush at the bottom
of the floor brush.
• Control with the power regulation button the desired
suction power.
10
Instruction manual

CLEANING AND mAINTENANCE

Emptying the dust compartment

• Push the release button for the dust compartment and
lift with your other hand the dust compartment out of
the base.
• Push the release button for the lid to open the dust
compartment, now you're be able to empty the dust
compartment
Cleaning the HEPA filter and the in / out coming
air filter.
• Push the release button for the dust compartment and
lift with your other hand the dust compartment out of
the base.
• Push the release button for the lid to open the dust
compartment, now you're be able to empty the dust
compartment.
• Turn the HEPA filter holder counter clockwise to
remove this out of the dust compartment.
• Turn the incoming air filter counter clockwise to
remove this.
• Pull on the backside of the vacuum cleaner the grid
out of its position and take the filter out of the grid.
• Rinse the three filters under a warm tap, if it's
necessary you can use a brush. Make sure that the
filters are completely dry before you refit them back in
the vacuum cleaner.
TM-2420