Prior To First Use - tomado TWC3701W Mode D'emploi

Before using the glass cleaner for the first time, proceed as follows: carefully unpack the glass cleaner and all accessories
and remove all packaging material and any promotional stickers. Keep the packaging (plastic bags and cardboard) out of reach
of children. After unpacking the appliance, carefully check it for external damage that may have occurred during transport.
Always place the glass cleaner upright on a sturdy, dry and flat surface.
Explanation:
1 Refers to a drawing number
3 Refers to a number in the drawing
The following components can be found in the packaging
1. Charger with cable
2. Basis - glass cleaner
3. Connection for charger
4. Indicator led
5. Spray bottle
6. Spray head
7. Holder - microfibre cloth
8. Coupling piece
9. Microfibre cloth (2x)
10. Squeegee attachment
11. On/off switch
12. Collection reservoir
ASSEMBLY
2 Attach the squeegee attachment to the basis of the glass cleaner and make sure you can hear it click.
3 Unscrew the spray head 2 from the spray bottle 1.
Place the holder for the microfibre cloth over the spray head 3.
Click the coupling piece 4 on the holder via the bottom side of the spray head, so that the spray head is clamped between
the holder and the coupling piece.
4 Attach the microfibre cloth 1 to the holder 2 and fasten it using the velcro.
5 Put some cleaning agent 1 in the bottle 2 and make up with water 3. Place the spray head with wiper 4 on the bottle
and screw tight 5.
CHARGING THE GLASS CLEANER
6 Plug the charger 1 in a socket and plug the cord in the connection point 2 of the basis of the glass cleaner.
Instruction: the indicator led flashes during charging. Once the appliance has been fully charged, the indicator led lights
up continuously.
Always remove the charger from the socket once the appliance is charged.
7 Use 1 the spray bottle to spray cleaning agent evenly on the surface to be cleaned 2. Use the microfibre cloth 3 to loosen
sticky grime.
If necessary, wet the microfibre cloth under the tap.
8 Press the on/off button ( ) to switch on the glass cleaner. The indicator led switches on. Caution: make sure the rubbers
of the squeegee are clean before you start.
Move the glass cleaner from the top down to absorb cleaning agent and wipe your windows clean without any streaks.
Instruction: difficult to reach spots can be cleaned vertically or horizontally (to a limited extent).

PRIOR TO FIRST USE

ASSEMBLY
1:
USING THE GLASS CLEANER
EN - 16