Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.1.3 REPLACING THE WIRE LINER
Ensure the gas and electrical supplies are disconnected.
STEEL
TEFLON
•
Connect the torch to the machine and install the wire into the feeding system.
7.1.4 HOW TO CHOOSE THE WIRE LINER
Mainly we can have 2 types of wire liners: Steel wire liners and Teflon wire liners.
• The steel wire liners can be coated or not coated: the coated wire liners are used for air cooled torches;
the wire liners which are not coated are used for water cooled torches.
• The Teflon wire liners are suggested for the welding of Aluminium, as they allow a smooth feeding
of the wire.
Colour
Diameter
7.1.5 GAS CYLINDER AND REGULATOR CONNECTION
WARNING: Cylinders are highly pressurized. Handle with care. Serious accidents
can result from improper handling or misuse of compresses gas cylinders. Do not
drop the cylinder, knock it over, expose it to excessive heat, flames or sparks. Do not
strike it against other cylinders.
The gas cylinder (not supplied) should be located at the rear of the welder, in a well ventilated area and
securely fixed to the work bench or to the wall to insure that it will not fall.For safety, and economy, ensure
that the regulator is fully closed, (turned counter-clockwise)when not welding and when installing or removing
the gas cylinder.
•
Turn the regulator adjustment knob counter-clock wise to ensure the valve is fully closed.
•
Install the gas regulator on the gas cylinder, tighten the connecting nut firmly to insure against gas
leakage.
•
Connect the gas hose to the gas regulator.
•
Open the cylinder valve, then set the gas flow to approx. from 5 to 15l/min. on the regulator.
7.1.6 FLUXCORE WIRE WELDING, "FCAW"
•
Connect the ground cable to the positive terminal of the Polari-
ty Change Board inside the spool compartment.
•
Connect the working cable to the negative terminal of Polarity
Change Board inside the spool compartment.
7.1.7 MIG WELDING, "GMAW"
•
Connect the ground cable to the negative terminal on the Pola-
rity Change Board inside the spool compartment.
•
Connect the working cable to the positive terminal of the Pola-
rity Change Board inside the spool compartment.
12
-ENGLISH-
•
Disconnect the torch from the machine.
•
Place it on a flat surface and carefully remove the brass
nut (1).
•
Pull the liner out of the hose.
•
Install the new liner and mount the brass nut (1) again.
In case you are replacing a Teflon wire liner, follow these
instructions:
•
Install the new liner followed by the collet (3).
•
Insert the O ring (4) on the wire liner collet (4)and re-
place the brass nut (1).
•
Cut the wire liner close to the brass nut
Warning: the length of the new wire liner must
be the same of the liner you have just pulled
out of the hose.
Figure 6
BLUE
RED
Ø 0,6-0,9
Ø 1,0-1,2
YELLOW
Ø 1,2-1,6
Figure 7
Publicité
Table des Matières
