Agilent Technologies Turbo-V 3K-T Notice De Mode D'emploi page 243

If PRINT is selected and a printer is connected on RS 232 line, an
unidirectional communication is established and every minute the
data are sent to the printer, even if the pump is not running.
The set of data available are:









Figure 25
Turbo-V 3K-T Rack Controller User Manual / 87-900-988-01
Pump speed Hz
Pump temperature
Pump current A
Pump power W
R1 condition
R2 condition
Confirm the selection by pressing the PUMP CURRENT push-
button.
In this way you enter into an operating phase named "Monitor
Relay Programming" described later.
Enter the value by pressing the PUMP CURRENT push-button.
Technical Information
Turbo-V 3K-T
(D)
17
Use
243/261