Promise Technology Vess A2600 Guide De Démarrage Rapide page 12

PROMISE Technology
Remove Disk Trays
Follow the instructions below to remove each disk tray to be used:
1. Grasp the handle and slide the latch to the left as far as it goes.
2. Press the square button to the right of the latch to release it. The latch with pop out.
3. Pull the latch out to open the door and lever the tray part of the way out. Then pull the latch
straight back about 2 centimeters to expose the front portion of the tray assembly. Grasp the
corners of the front assembly with the thumb and forefinger of each hand and pull the tray
completely out of the enclosure, sliding it straight out. The tray is now ready to receive a new
hard disk.
Figure 12: Remove disk tray from enclosure
1. Carefully lay the disk drive into the drive carrier at the front, so that the screw holes on the sides
line up.
2. Insert the screws through the holes in the drive carrier and into the sides of the disk drive.
Install only the counter-sink screws supplied with the drive.

Install four screws per drive.

Snug each screw. Be careful not to over-tighten.
3. Reinstall the drive carrier into the enclosure.
Repeat steps 1 through 3 until all of your disk drives are installed.
Figure 13: Mount HDD in disk tray
10