Standard Accessories; Optional Accessories; Final Assembly; Installation - Metabo TF 100 M Instructions De Service

This machine or any of its parts should not be altered or changed from standard specifications. The user of this
machine shall have the sole responsibility for any malfunction which results from improper use or unauthorized
modification from standard specifications, faulty maintenance, damage or improper repair by anyone other than
qualified persons approved by metabo or its representatives.
Metabo reserves the right to change specifications and design without prior notice and without incurring
obligation of any kind.
Equipment referred to as available or optional may be at extra cost.
3

Standard Accessories

Spacing collars: 1 pc. 25 mm, 1 pc. 16 mm,
Spindle nut:
Fence
4

Optional Accessories

Table Extension TF 100
Sliding Carriage TF 100
Moulding Tools
5

Final Assembly

Set table extension level with the table.
Place fence on table and screw
starknobs onto stud bolts.
6

Installation

Important!
This spindle moulder model TF 100 M must be anchored to the floor for
stability. A machine not anchored to the floor may fall over while in
operation.
Use suitable means for anchoring, e.g. anchoring bolts or expansion
anchors Ø 8 mm.
2 pcs. 10 mm, 2 pcs. 8 mm,
2 pcs. 5 mm
M 30x2
Stock-no. 0914003598
Stock-no. 0914015600
see separate catalogue
Install cutter guard carrier on the fence.
Use 4 each
- hexagon head screw M 6x25
- hex. nut M 6 self-locking
Slide hexagon bar into fence carrier
and lock with starknob screw.
Fence plates
SUVA style safety cutter guard
Tool set
Instructions
Screw both stud bolts into the tapped
bore holes of the table.
Install holddown shoe and spring on
hexagon bar.