Faber SCIR3014SSNB-B Instructions D'installation page 19

Surface of Downdraft Vent
To avoid damaging the finish, clean
downdraft vent with soap and water or
Stainless steel cleaner.
Do not use scouring powder or abrasive
solutions.
Grease Filter Care
Frequently remove and clean the filters in the
retractable section of the downdraft vent. This
will improve the operating efficiency of the
downdraft vent system.
To Remove Filters:
1. Place fingertips in the embossment at the
top for the filters.
2. Press down on the filters far enough for the
tab at the top of the filters to clear.
3. Pull forward to release the filter from its
groove.
To Clean:
1. Remove the filters and clean / soak them in
hot dish detergent and water. Because the
stainless steel on the filters could be
scratched, it is not recommended that
the filters be placed in a dishwasher. The
downdraft vent will not operate when the
filters are not in place.
2. Dry the clean filters and reinstall, making
sure that they lock into place.
To Replace Filters:
1. Place filters into the retractable section of
the downdraft vent.
2. Place fingertips into the embossment at the
top of the filters and push down and back to
allow the top tabs to snap in place.
NOTE: Downdraft vent will not operate if the
filters are not in their proper position. If the
filters top tabs are not locked behind the top
flange, the vent may retract but not raise back
up.
If retractable downdraft vent does not
operate after clean filters have been
installed: Push the filter in as far as it will go.
When the filter is removed, the microswitch
behind the filter is inactivated. This feature will
not allow the vent system to operate until the
filter is properly installed.
DOWNDRAFT SYSTEM CARE
Vent System Use
For gas cooking surfaces, the vent system may
affect flame stability and cooking performace.
To improve the burner performance, decrease
the blower speed or increase the burner
setting.
The flame sensing ignitions on some gas
cooking surfaces may be affected by the
downdraft by dispersing the flame away from
the spark igniter. This may cause the spark to
keep running while trying to reignite the burner
that is already lit. The resolve this issue,
decrease the vent speed or increase the
burner setting.
I
GB Electric Diagram
F
WARNING: Disconnect the power supply and
lock out the service panel before cleaning or
servicing. To clean, remove the cover and
vacuum the blower and housing, being
careful not to damage the blower impeller.
The motor is permanently lubricated, do
not oil or disassemble.
A- Grease filter removal tab
B - Left grease filter
Schema Elettrico NL Schema Electrisch
C - Right grease filter
E Esquema Eléctrico
Schéma Electrique PT Esquema Eléctrico
4436004880 H90_040 r1
Version 3/15 - Page 20