Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ELECTRICAL CONNECTION WITH REMOTE BLOWER
- If using a remote blower, install a connection cable between the range hood and the remote
blower.
- See the Remote Blower instructions for more guidelines
- Additional knock outs should be used for the remote blower wiring
- Install a suitable UL listed cable clamp or conduit fitting into the knock out
- Connect the home power into the box as described on the previous page
- Using FIGURE 34 as a guide, connect the remote blower wiring as follows into the downdraft
box: Blue on the right side, brown on the left side and the ground / green wire goes under one
of the green ground screws.
- Ensure that the terminal screws are tightly holding all wires into place
- The remote blower will be connected to the additional control cable
- Close the terminal box and attach with a screw (FIGURE 35)
- Turn the power back on
FIGURE 35
FIGURE 34
Version 3/15 - Page 18
Publicité
Table des Matières
