Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
- Push the side covers into place on the
mounting brackets on top of the counter and
lock them in place (FIGURE 29)
- Connect the appliance to the electric power
supply (see the next page)
- Press the stainless top strip onto the hood.
Push the On / Off push button on top of the
hood, the hood vent will rise.
- Remove the labels, screw and brackets as
shown in FIGURE 30. This bracket is used for
support during transportation
- Connect the top strip to the hood with nuts
underneath the top strip to the screws on the
right and left end to secure the top strip to the
hood. See FIGURE 31, use a size 7 mm nut
driver tool.
- Install grease filters (PAGE 18, FIGURE 36)
- Connect 6" round ducting to the unit.
FIGURE 29
PRODUCT INSTALLATION
FIGURE 31
REMOTE BLOWER INSTALLATION
- When using the remote blower, a connection
plate must be installed on the hood instead of
a blower box. It can be mounted to the front
or back of the unit.
- If the connection plate is on the front of the
unit, then the ducting can only come out of the
front
- If the connection plate is on the back of the
unit, then the ducting can only come out of the
back
- The connection plate is installed using 4
screws as shown in FIGURE 32
- The cover plate is installed onto the housing
on the opposite side of the connection plate
(FIGURE 33)
- The remote blower is connected to the
downdraft unit with an additional control cable.
See the installation instructions for the remote
blower. The control cable will be connected in
the wiring box of range hood.
- Use 10" round ducting to connect the remote
blower.
FIGURE 30
FIGURE 32
FIGURE 33
Version 3/15 - Page 16
Publicité
Table des Matières
