Table Des Matières - Faber SCIR3014SSNB-B Instructions D'installation

INSTALLING IBDD600-B IN BACK OF THE HOOD
The blower box can also be installed on the
back of the hood to accommodate the
installation of a cooking range, range top or
wall oven / cook top in front of the hood.
- Remove the large cover on the back of the
hood. (FIGURE 23)
- Turn the venting collar on the blower box to
the desired direction - left, right, down. Plug in
the wiring cable from the motor kit to the hood
and Mount the blower box to the housing
using 4 screws . (FIGURE 24)
- When finished, mount the previously
removed cover onto the front of the unit
(FIGURE 25)
FIGURE 25
PRODUCT INSTALLATION
FIGURE 23
FIGURE 24
PREPARE ELECTRICAL CONNECTION
- Remove the cover of the terminal box
(FIGURE 26)
- Decide whether the power source should
enter the hood from below or from the back.
Remove the respective knock out
- If the hood is being installed with a remote
blower, remove the knock out for the control
cable
- Install a UL listed clamp or conduit fitting in
the knock out (not included) (FIGURE 27)
- With assistance for another person lift the
hood into the cabinet cut out. The top
mounting angles should rest on the counter
- Secure the hood to the floor and countertop
(FIGURE 28) with screws into the previously
drilled holes
FIGURE 26
FIGURE 28
FIGURE 27
Version 3/15 - Page 15