Position Indicator - Truma Mover XT4 Instructions De Montage

Place the drive assemblies with cross-struts and mounting
kit (b) on the vehicle frame and bolt them on with the two
bolts (c) in such a way that it is just possible to move them
along the frame.
The gripper (a) must be lying flat against the chassis
frame (e) in its entirety and also flat against the leg (d).
Fig. 19
b
Fig. 20
If the frame is not high enough, Truma can provide 30 mm
and 60 mm spacer sets as accessories in order to compen-
sate for this.
30 mm spacer set, part no. 60030-95000
60 mm spacer set, part no. 60030-95100
Make sure that there is adequate ground clearance (at least
110 mm).
Mover
min. 110 mm
Fig. 21
Set the correct distance between tyres and rollers (20 mm)
with the spacer gauge provided by moving the drive assem-
blies (in the disengaged position) in the longitudinal direction.
The adjustable centre bar makes it possible to adjust to the
frame width.
20 mm
Fig. 22
d
e
c
a
b
min. 110 mm
20 mm
Move the drive assemblies in a lateral direction in such a way
that as much of the tread area of the tyre / drive roller as pos-
sible is covered.
Once the drive assemblies have been correctly positioned,
tighten the bolts (c) of the mounting set a little, then check the
required distances again. The weight of the caravan must be
resting on the wheels when doing this.
Place the adjustable centre bars in the middle (mark the position
before assembly if necessary), tighten the 2 bolts (M8 x 30,
20 Nm) and lock using the lock nuts.
Re-check the distance of 20 mm from the tyre (with the
wheels under load). Then tighten the 2 bolts of the mounting
set (M10) alternately to 25 Nm.
Fig. 23
The bolts are coated with sealant, and must therefore
only be bolted in once.

Position indicator

Indicates how far the Mover® XT4 is engaged.
No figure visible: Disengaged position
Figures 1 to 3 visible: Engaged position
Fig. 24
Mover
25 Nm
Mover
23