Directional Osd Page; Encoder Parameters Page - Stahl EC-940-PTZ-HF Série Manuel D'instructions

10.2.12 Directional OSD Page

The device supports definition of four pan regions
and information text video display based on the
position of the Pan & Tilt.
You can define the following settings for each area:
• Enabled: Each area can be configured as disabled,
enabled clockwise and enabled anti-clockwise.
• Start: The point in which the OSD region begins
(expressed in sexagesimal degrees).
• End: The point in which the OSD region ends
(expressed in sexagesimal degrees).
• The dimension and the text to display.
Fig. 41
Example of configuration: OSD region clockwise.
Fig. 42 Example of configuration: OSD region anti-clockwise.
MNTCMPXHDB_1824_EN
Start
0°
Stop
Start
0°
Stop
Fig. 43

10.2.13 Encoder Parameters page

In the Encoder Settings menu, it is possible to
configure the video flows of the device (3 flows).
All the video flows can be coded with the following
characteristics: H264, MPEG4, MJPEG.
For all flows, the following options can be set:
Framerate, (fps), Bitrate limit (kbit/s), Quality, I-Frame
H264 Interval, Coding profile.
It is possible to configure the address for
configuration of multicast video streaming.
Editing this setting will cause the device to restart.
Encoders Default: The button resets the encoders
settings to default configurations.
Fig. 44
33