Information On Disposal And Recycling; Troubleshooting - Stahl EC-940-PTZ-HF Série Manuel D'instructions

14 Information on disposal
and recycling
The European Directive 2012/19/EU on Waste
Electrical and Electronic Equipment (WEEE) mandates
that these devices should not be disposed of in the
normal flow of municipal solid waste, but they should
be collected separately in order to optimize the
recovery stream and recycling of the materials that
they contain and to reduce the impact on human
health and the environment due to the presence of
potentially hazardous substances.
The symbol of the crossed out bin is marked
on all products to remember this.
The waste may be delivered to appropriate collection
centers, or may be delivered free of charge to the
distributor where you purchased the equipment at
the time of purchase of a new equivalent or without
obligation to a new purchase for equipment with size
smaller than 25cm (9.8in).
For more information on proper disposal of these
devices, you can contact the responsible public
service.
38

15 Troubleshooting

This product must only be repaired by
suitably trained personnel or under
the supervision of STAHL personnel in
accordance with the foreseen terms and
conditions: IEC/EN60079-19.
Contact an authorized support centre if the
problems listed below persist or you have
any other issues that are not described
here.
PROBLEM The product does not go on.
CAUSE Wiring error, blown fuse.
SOLUTION Make sure the connections are
correct. Check the continuity of
the fuses and replace them with
the indicated models should they
fail.
PROBLEM The shooting area do not
correspond to the selected
preset position.
CAUSE Loss of absolute position
reference point.
SOLUTION Reset the equipment by
switching off and on again.
PROBLEM The device does not move
during the start-up phase.
CAUSE The ambient temperature is too
low.
SOLUTION Wait until the end of the pre-
heating procedure. The following
message is displayed on the
web page: De-Ice procedure in
progress.
MNTCMPXHDB_1824_EN