Video Analysis Page; Wash System Page; Movement Parameters Page - Stahl EC-940-PTZ-HF Série Manuel D'instructions

10.2.8 Video Analysis Page

The device can be configured to emit motion
detection alarms using ONVIF events.
This page allows you to define the following settings:
• Enable emission of motion detection events.
• Configure the algorithm sensitivity level.
Fig. 36

10.2.9 Wash System Page

Do not use the wiper if the outside
temperature is below 0°C or in case of ice.
From the menu, it is possible to configure the device
wash system functions.
Fig. 37
MNTCMPXHDB_1824_EN

10.2.10 Movement Parameters page

From menu entry Movement Parameters it is possible
to control, via web, all Pan & Tilt parameters.
• Options
• Offset Pan: The pan & tilt has a mechanically
defined 0° position. The Offset Pan function
allows the definition of a different 0° position
using software.
• Economy Mode: It reduces the motor's torque
when the Pan & Tilt is at standstill to decrease
consumption. Do not enable in the presence of
strong wind or vibrations.
• Autoflip: Turn the Pan & Tilt by 180° when the
tilt of the Pan & Tilt reaches the end run. It makes
it easier tracking subjects along corridors or
roads.
• Ceiling Mount: It rights the image and reverses
the handling controls.
• Manual Controls
• Maximum Speed: Sets the maximum manual
speed.
• Scan Speed: The speed, measured in degrees
to the second, at which a preset is reached by
explicit operator request.
• Tilt Factor: Sets the reduction factor of the tilt
axis manual speed.
• Speed with Zoom: When enabled, this
parameter automatically slows down the Pan &
Tilt speed, based on the Zoom factor.
31