Practical Applications; Important - Metabo HPT C 7WDM Mode D'emploi

4. Detent setting plate adjustment
Fig. 19

PRACTICAL APPLICATIONS

WARNING:
Never touch the moving parts.
●
Should the saw blade be stopped or make an abnormal noise during operation, turn
●
off the switch immediately.
Don't remove the saw from work piece during a cut while the saw blade is moving.
●
Always wear eye protection with side shields that meets the requirements of ANSI
●
Standard Z87.1. Ordinary eyeglasses do not provide adequate protection.
Avoid cutting any material like metal, etc., that give off sparks.
●
Do not use any abrasive wheels.
●
Use only blade diameter specifi ed on the product nameplate.
●
For your own safety, never connect the saw plug to any power source outlet until
●
all assembly and adjustment are completed, and you have read and understood the
safety and operating instructions. An accidental start-up can cause injury.
CAUTION:
Always take care in preventing the power cord from coming near the revolving saw
●
blade.
Before starting to saw, ensure that the saw blade has reached full speed revolution.
●

IMPORTANT:

Always make sure the depth adjustment locking lever is in the down position
and locked before operating the saw.
1. Guide notches
(1) The front of the base plate has a 90° guide notch and a 45° guide notch for vertical and
bevel cutting. The guide notches enable you to guide the saw along the cutting lines marked
on the workpiece.
(2) Also, the saw has the inner guide notches located on the insides of the base plate as shown
in Fig. 20 to keep the straight cutting.
Hex screw
Lock nut
NOTE
: In order to make the correct
adjustment, make sure that the
saw blade and base plate are
right angles when the product is
set at 90°.
If the bevel accuracy adjustment is necessary,
loosen the lock nut with a 7 mm or adjustable
wrench and turn the hex screw in or out with a
2 mm hex wrench until the bevel accuracy is
achieved. Then, tighten the lock nut.
English
25