Metabo HPT C 7WDM Mode D'emploi page 27

4. Turning the saw on
WARNING:
(1) Using a pencil or marker mark the line to be cut on the workpiece.
(2) Place the saw on the workpiece, align pre-marked guide line with the saw blade, using the
guide notch at the front of the base plate.
NOTE
: This relationship of base plate to workpieces should remain unchanged
regardless of the inclination of the base plate.
(3) Use both hands to hold the saw fi rmly, one hand on the auxiliary handle and the other hand
on the trigger switch handle.
(4) The trigger switch should be turned ON by being pressed with one fi nger before the saw
blade comes into contact with the workpiece.
NOTE
: The trigger switch is turned OFF when the trigger switch is released.
(5) Moving the saw straight at a constant speed will produce optimum cutting.
NOTE:
This saw has no provision to lock the trigger in the on position and should
never be locked on by any other methods.
Pre-marked
guide line
5. Installing the rip fence (optional accessories)
Rip fence locking bolt
Base plate
Fig. 24
To reduce the risk of serious personal injury, hold saw with both
hands when starting the saw to avoid kickback.
Auxiliary handle
Rip fence
Trigger switch
Fig. 23
(1) Insert the rip fence through the holes of the
base plate.
(2) Adjust the rip fence to the desired position.
(3) Insert and tighten the rip fence locking bolt.
English
Trigger switch handle
27