Metabo HPT C 7WDM Mode D'emploi page 10

English
11. Handle tool correctly.
Operate the tool according to the instructions provided herein. Do not drop or throw the tool.
Never allow the tool to be operated by children, individuals unfamiliar with its operation or
unauthorized personnel.
12. Keep motor air vent clean.
The tool's motor air vent must be kept clean so that air can freely fl ow at all times. Check for
dust build-up frequently.
13. Operate power tools at the rated voltage.
Operate the power tool at voltages specifi ed on their nameplates. If using the power tool at a
higher voltage than the rated voltage, it will result in abnormally fast motor revolution and may
damage the unit and burn out the motor.
14. Do not run the saw while carrying it at your side.
15. Keep all screws, bolts and covers tightly in place.
Keep all screws, bolts, and plates tightly mounted. Check their condition periodically.
16. Do not use power tools if the housing or handle is cracked.
Cracks in the tool's housing or handle can lead to electric shock. Such tools should not be
used until repaired.
17. Blades and accessories must be securely mounted to the tool.
Prevent potential injuries to yourself or others. Blades, cutting implements and accessories
which have been mounted to the tool should be secure and tight.
18. Never use a tool which is defective or operating abnormally.
If the tool appears to be operating unusually, making strange noises, or otherwise appears
defective, stop using it immediately and arrange for repairs by a metabo HPT authorized
service center.
19. Carefully handle power tools.
Should a power tool be dropped or struck against hard materials inadvertently, it may be
deformed, cracked, or damaged.
20. Do not wipe plastic parts with solvent.
Solvents such as gasoline, thinner benzine, carbon tetrachloride, and alcohol may damage
and crack plastic parts. Do not wipe them with such solvents. Wipe plastic parts with a soft
cloth lightly dampened with soapy water and dried thoroughly.
21. Never wear gloves made of material liable to roll up such as cotton, wool, cloth or
string, etc.
22. Defi nitions for symbols.
V ............. volts
Hz ........... hertz
A ............. amperes
n
.......... no load speed
0
---/min ..... revolutions per minute
........... alternating current
10