Design And Function; Electrical Connections; Voltage Supply; Power Supply Unit - WIKA CPC2000 Mode D'emploi

4. Design and function

4. Design and function
4.1

Electrical connections

The electrical connection is located on the rear of the CPC2000.
1
2
3
4.2

Voltage supply

The low-pressure controller is factory-set for connection to a voltage supply of DC 24 V.
The connection for the power supply unit is located on the rear of the instrument.
The mains plug of the charger/power supply unit must always be plugged into a mains
■
socket and accessible, so that one can always remove it from the mains socket without
difficulty.
The internal lithium-ion rechargeable battery, which can be easily charged with the
■
battery charger supplied with the equipment, serves as the voltage supply for the
instrument.

4.2.1 Power supply unit

DANGER!
Danger to life caused by electric current
Upon contact with live parts, there is a direct danger to life.
▶
With operating or charging using a defective or non-original power supply
unit (e.g. short-circuit from the mains voltage to the output voltage), this can
result in life-threatening voltages at the instrument!
▶
Only use the power supply unit supplied with the instrument (original power
supply unit, Mascot model 9926)!
▶
Only use a battery charger that is fully functional or undamaged.
▶
If there is any visible damage to the case or the wiring, do not use the power
supply unit!
WIKA operating instructions, model CPC2000
USB interface
1
RS-232 interface
2
Connection for power
3
supply unit
EN
11