Getting The Best Results - Num'axes CANICOM Soft Guide D'utilisation

To check the condition of the battery, observe the indicator light located on the front of the receiver collar:
- battery sufficiently charged: flashes slow green.
- weak battery: flashes quickly red.
Replace the old battery with a new one (3-V Lithium CR2450) (See § First use from new – Fitting the
battery in the receiver collar) then check the receiver collar operates correctly.
How to check that your is functioning properly

You can check that your is operating correctly at any time.
- Turn "On" the remote control and receiver collar.
- Check the functions of the product as follows:
- when you press the
- when you press the
- when you press the V V V button, the collar must vibrate for as long as the button is pressed
(but 8 seconds max)
- when you press the V button, the collar must vibrate for approximately 1 second.

Getting the best results


The training instructions you send to your dog are sent from the remote control to the receiver collar by
radio waves.
These radio waves are sensitive and the range reaches approximately 200 meters (depending on geography
and environment).
The performances of your will be optimal if you respect the following recommendations:
- To obtain a good radio range, do not cover the part located above the indicator lights when you hold the
remote control in your hand.
- The position of the receiver collar around the neck of the dog should be in the following way: the On/Off
indicator light is visible and is not in contact with the breast of the dog.
- Check the batteries (remote control and receiver collar) before using the unit and replace them as soon
as the level of load is weak.
- The performances of the batteries decrease slightly under temperatures lower than 0°C. If possible
keep the remote control warm (e.g. inside a pocket) before using it.
NUMAXES guide canicom soft -B.indd 21
Gb - 21
button, the collar must emit beep sounds
button, the high luminosity LED in the collar must light
13/06/2017 09:34