Equipment Description And Use; Safety; What You Need To Take Into Account - Pelgrim MWA130 Notice D'utilisation

1 Equipment description and use

Appliance description
1 - Moisture collector
2 - Grease filters
3 - Control panel
4 - Lighting
Controls
5 - Lighting switch
6 - Switch for electrical flap or speed regulator fan
Depending on the quantity of moisture you can choose a higher or lower position. Start
the exhaust hood 5 minutes before cooking. Leave the exhaust on after cooking for
another 15 minutes.
When an exhaust hood is connected to a central exhaust circuit you are only able to put
the lights on and off and to open and close the electrical flap.
Apply carbon filter (only in case of re-circulation)
Place the carbon filter in the middle on the motor housing cap and turn it to the right one
full turn.
Introduction
When you read this users manual you will be quickly informed of all the options the
appliance offers you. You will be informed of safety measures and maintenance of the
appliance.
Keep this users manual and the installation guide. This will be of use for any user of this
appliance.
34
5
5

2 Safety

2.1 What you need to take into account

Attention! Make sure the appliance is installed by an authorised installer (see
"Installation" chapter). Do not connect the appliance to the flow network before
completing the installation.
Connect the appliance in accordance with the applicable regulations in your area.
•
We advise you to wear protective work gloves during the installation of the exhaust
•
6
hood due to possible sharp edges.
The appliance has been manufactured in accordance with the latest safety standards.
•
However we do advise that mentally handicapped, disabled or retarded individuals do
6
not use this appliance without the proper supervision of a competent person. The same
applies to children.
Never use the exhaust hood when the grease filters have not been properly installed!
•
Do not lean against the exhaust hood.
•
Make sure there is sufficient circulation when you use the exhaust hood on a gas
•
cooker.
The exhaust exit must never be connected to a smoke duct which is also used for other
•
heating appliances.
Never flambé under the exhaust hood and always clean the filters on time. Frying needs
•
to be done under constant supervision to prevent the heated fat from catching fire.
The exhaust hood needs to be cleaned regularly (at least once a month) on the inside
•
as well as on the outside. When the filters are insufficiently cleaned or replaced, this will
result in a fire hazard.
If the connection cable becomes damaged, it should be replaced by the manufacturer's
•
service department or by a person with equivalent qualifications, in order to prevent
dangerous situations from arising.
First disconnect the appliance from the socket when you replace the lights! Only use
•
identical lamps with the wattage indicated. Only use the exhaust hood with lamps
installed to reduce the risk of electrical shock.
The filter grid can be removed by pulling it straight down. Do this by using both hands.
•
The filter grid with grease filter is becoming hot during operation. Wait a minimum of
•
30 minutes after cooking before cleaning it.
35