Maintenance; Cleaning; Cleaning And Replacing The Grease Filters - Pelgrim MWA130 Notice D'utilisation

3 Installation
3.4 Fitting the panel door
1. Open the door, push the brackets in and remove the door.
2. Place the panel door with the back up on a flat surface.
3. Put the drilling jig (N3) on the back of the panel door. The arrow of the jig should point
upwards.
4. Drill mounting holes of between (K) 2.5 mm to 6 mm deep.
5. Attach the metal panel with the enclosed 8 screws.
6. Fit the door, including panel, onto the exhaust hood. First the top and then the
bottom.
7. Check whether the door opens and shuts properly.
40

4 Maintenance

Attention! Turn the mains voltage off during cleaning and maintenance by
unplugging the plug from the socket or by switching off the circuit-breaker in the
meter cupboard.

4.1 Cleaning

The exhaust hood can be cleaned with soapy water and a soft cloth, then rinse with clean
water. Do not apply aggressive cleaning agents such as soda. The paintwork on the
exhaust hood will remain shiny when it is periodically rubbed with wax.

4.2 Cleaning and replacing the grease filters

Open the lock on the filters and remove the filters.
Attention! Clean the grease filters each
month with soapy water. When washed
in a dishwasher, the grease filter may
discolour slightly. This is normal and
does not affect its filtering capacity.
4.3. Changing the carbon filters
The saturation of the filter depends on the intensity of use. The carbon filter needs to be
replaced at least every four months.
Attention! The carbon filter cannot be
washed for reuse. Saturated carbon is not
environmentally friendly, change the filter
regularly.
4.4 Removing and fitting the door
Open the door and push the brackets onto the side of the door.
Pull the door out of the conduit. Place the panel door on the exhaust hood again. First the
top and then the bottom.
2x
41