Canceling The Demo Mode; Setting The Clock; Detaching The Front Panel; Attaching The Front Panel - Sony MEX-BT3000 Mode D'emploi

Canceling the DEMO
mode
You can cancel the demonstration display
which appears while this unit is turned off.
1
Press and hold the select button.
The setup display appears.
2
Rotate the control dial until "DEMO"
appears, then press it.
3
Rotate the control dial to select
"DEMO-OFF," then press it.
The setting is complete.
4
Press (BACK).
The display returns to normal reception/
play mode.

Setting the clock

The clock uses a 24-hour digital indication.
1
Press and hold the select button.
The setup display appears.
2
Rotate the control dial until "CLOCK-
ADJ" appears, then press it.
The hour indication flashes.
3
Rotate the control dial to set the hour
and minute.
To move the digital indication, press
 –/+.
4
After setting the minute, press the
select button.
The setup is complete and the clock
starts.
To display the clock, press .
6

Detaching the front panel

You can detach the front panel of this unit
to prevent theft.
Press and hold  .
1
The unit is turned off.
2 Press the front panel release button ,
then remove the panel by pulling it
towards you.
Caution alarm
If you turn the ignition switch to the OFF
position without detaching the front panel,
the caution alarm will sound for a few
seconds. The alarm will only sound if the
built-in amplifier is used.
Note
Do not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in a
parked car or on a dashboard/rear tray.

Attaching the front panel

Engage part  of the front panel with part
 of the unit, as illustrated, and push the
left side into position until it clicks.