Programming The Easytouch25; Method A: Programming Using The Brand Search Method - Marmitek EASYTOUCH 25 Mode D'emploi

MODE: (AUDIO) AM or FM Tuner selection
SLEEP: (TV Only) To turn off your TV after a period of 1 to 99 minutes.
Proceed as follows:
1. The remote must be in TV Mode with the "second" display screen being shown.
2. Press and hold the Touchscreen "SLEEP" Key until the LED remains on (this occurs
after approximately 2-3 seconds) and display shows the Sleep Setup Screen.
3. Release the "SLEEP" key.
4. Press and release the numerical keys (01-99) for the time required. The LED will
blink off to indicate keypress acceptance and the remote display will return to
normal operation.
5. TV Sleep Timer now set. Leave the Remote pointing towards the TV with an
unobstructed path.
To cancel the Sleep Timer, press and release the Power key in TV Mode or press and
hold the SLEEP key until the remote beeps twice.

6 Programming the Easytouch25

You can program the EasyTouch 25 in three different ways.
1. When your equipment is one of the following six brands (Philips, Sony, Thomson,
Saba, Grundig, Nokia) you can use the Brand Search method. Use method A in this
case.
2. Are you using another brand of equipment ? If so, find your brand in the code book,
and use method B to program your EasyTouch35.
3. If the above two methods are not working, you can use method C: search for the
codes manually.
4. If none of the above methods work with your equipment, you can add the codes
yourself by learning the codes of your original remote. This is explained in chapter 11.
You program the ET25 using the Setup key and following the procedures below. Each
keypress is acknowledged with an LED blink and a beep from the remote. 3 LED blinks
and a beep indicate an incorrect or invalid entry.

Method A: Programming using the Brand Search method

It is possible to search for your appliance's code by entering the brand of the appliance
you wish to control.
1. Make sure your appliance is switched on. If not switch it on manually
2. Activate your ET25 remote by touching the screen
3. Press and hold Setup key until the LED remains on (this occurs after approximately 2-
3 seconds) and display shows Main Setup Screen.
8 MARMITEK