Marmitek EASYTOUCH 25 Mode D'emploi page 17

5. Press and release a digit key 1-9 (1=10 seconds, 2=20seconds, etc) followed by
ENTER. The display will return to the Main Setup Screen.
6. Touchscreen On time setting now complete.
7. Press the Touchscreen "EXIT" key to return to normal status.
3. User Master Reset:
To reset the remote defaults back to factory settings.
1. Press and hold Setup key until the LED remains on and display shows the Main Setup
Screen.
2. Release Setup key.
3. Press and hold the Setup key for approximately 5 seconds until the LED blinks on then
turns off.
4. Default Reset now complete and remote will be in normal TV Mode.
4. Channel Scan/Search Key (Touchscreen):
The Channel Scan/Search function is only available in TV, DVD, CBL/SAT and CD/Audio
Modes. Pressing the Touchscreen "SEARCH" Key allows the User to sequentially scan up
available program channels. This key cannot be learned.
When pressed, a Channel Up command for the Current Mode code is sent once every 3
seconds. When any other key is pressed the scan will stop. Scanning will automatically
time-out after 2 minutes if no key is pressed.
5. VideoPlus/Showview Key SV/V+ (Touchscreen):
This key allows the User to directly access their VCR VideoPlus or Showview function if the
feature is available on their VCR. If VideoPlus or Showview feature is not available then
this key will allow direct access to any VCR Timer or Menu operation (if present) as an
alternative. The VideoPlus/Showview function is only available in VCR programmed
Modes. This key can be learned if required.
6. All Power Off Feature:
If the Power key is pressed twice within a 1 second period, and the second Power key-
press is held for more than 2 seconds, then the remote will send the Power command for
all Modes.
7. TV Volume/Mute Punch-Through:
The TV Volume/Mute punch-through feature allows the User to control the Volume and
Mute function of their Television in any Mode programmed to be a VCR (inc. DVD), Cable
or SAT library device without the need to change to TV Mode.
8. CBL/SAT Volume Control:
Some Cable and Satellite have their own volume control. By default in CBL/SAT modes,
the ET35 Volume and Mute key control the TV volume. To change the volume and mute
control either to TV or CBL/SAT for CBL/SAT mode, proceed as follows:
1. Press and release the TV mode key (TV must be in TV mode for this procedure).
EASYTOUCH 25 17