Marmitek EASYTOUCH 25 Mode D'emploi page 15

Tips On Learning:
• Always use of new batteries for the ET25 and original remote
• It is recommended that you carry out a Master Clear before using the learn function
for the first time. You can find the method below.
• Place the original remote to the base of the Touchscreen so the IR LED on the original
remote is in line with the Touchscreen opto-diode input (See graphic A on page 3).
• Keep the distance between the two remotes to about 5 cm.
• Experiment by Learning 2 or 3 keys initially and then carry out a Master Clear before
completely Learning your original remote's keyboard.
• Do not attempt to Learn directly under an incandescent or low-energy light.
• When Learning a key, do not release the key being Learned until the display returns
and the LED remains on. This can take 2-3 seconds.
• No functions may be stored under the Touchscreen SCREEN, LIGHT, SLEEP, P<P,
SEARCH keys or under rubber keys Setup, Macro, TV, VCR, DVD, CBL, SAT, or
Audio keys. It is not possible to learn under "shifted keys".
Master Clear - To Clear all stored Learned Commands (recommended for first time
Learning)
1. Press and hold the Setup key until the LED remains on (this occurs after approximately
2-3 seconds) and the display shows the Main Setup Screen.
2. Release the Setup key.
3. Press and hold the Touchscreen "LEARN" key until the Main Setup Screen is displayed
(after approx. 5 seconds). All Learned Command entries are now cleared.
4. Press the Touchscreen "EXIT " key.
To Learn Commands:
1. Press and hold Setup key until the LED remains on (this occurs after approximately 2-3
seconds) and the display shows the Main Setup Screen.
2. Release Setup key.
3. Press and release Touchscreen "LEARN" Key.
4. Display will show the Mode Setup Screen. Press and release desired Mode key (TV,
VCR, SAT, etc.) on the rubber keypad.
5. Display will show the Learn Setup Screen. This screen comprises the current labels for
the Mode along with the SETUP and LEARN Touchscreen labels. Press and release the
ET25 remote key (rubber or Touchscreen) to be taught with the original remote key
code. Use the Touchscreen "SCREEN" Key to toggle the screen keys displayed.
6. Press and hold the original remote key until the LED blinks off once and the display
shows the Learn Next Setup Screen (this process can take up to 2 or 3 seconds to
complete). If there is a problem with learning the LED will flash three times but still
remain in the Learn routine with the Learn Next Setup Screen displayed. To learn
another key, press and release the Touchscreen "LEARN" Key and repeat from Step
"5". To save and exit from the Learn routine, press and release the Touchscreen "OK"
Key. Return to the Main Setup Screen.
EASYTOUCH 25 15