Haier HLP21N Guide De L'utilisateur page 15

6. The drain hose must be placed into a drainpipe or sink at least 1-1/2 inches
in diameter. Use the gooseneck drain hook to hold the hose in place. To avoid
possible water back-up, the drain hose must reach a height of at least 31-1/2
inches minimum and 40 inches maximum.
Drain Hook
Final connection of washer to sink should look like this.
7 .
Plug fin the washer to a regular 120 Volt / 60 Hz, 15 Amps outlet, only after
all water and drain lines are connected .
Note: Carefully inspect for any leaks around the machine and at the back. If
there is a leak, check if any connections are loose. You may need to
tighten any loose connections. Do not remove the water absorption
cushion. Check before each use to make sure it is not damaged.
CAUTION! If after completing these steps you are still unsure whether unit has
been properly installed, contact a qualified installer. We recommend
that the washer be installed by a certified technician to ensure that it
is properly installed.
Laundry tub:
Just hang hook over side of sink or for a
more permanent use plastic ties.
Plastic Tie
Water inlet hose
Drain hose
English
Drain Hook
Washer
Rear View of Washer
14