Ryobi RBV26B Manuel D'utilisation page 21

■ Figure sheet
NOTE: Read and remove all hang tags and store with your
operator's manual.
ASSEMBLING THE BLOWER TUBES
See fi gure 2.
■ Close the vacuum inlet cover securely. Make sure the
metal contact on the inlet cover is inserted into the
positive switch.
■ Align the raised tabs on the blower housing outlet to
the slots at the upper tube; slide and tighten securely
by twisting; press slider plate into the slot of the
positive switch to make sure the switch is engaged
and ready to operate.
■ Connect the lower and upper tubes together.
■ Connect the nozzle.
■ To remove the blower tube, pull out the slider from the
positive switch, then rotate the tubes to remove them
from the blower housing outlet.
INSTALLING THE VACUUM BAG
See fi gure 3-4.
■ Unzip the vacuum bag and place the adaptor inside
as shown. Push the vacuum bag adaptor through the
open ing in a direction opposite to the zipper. The wider
end of the adaptor will remain in the vacuum bag when
installed properly.
■ Align the raised slots on the vacuum bag adaptor with
the raised locking tabs on the blower housing outlet;
push the bag adaptor onto the housing. Twist to lock
into place, press the metal contact into the positive
switch slot to make sure the switch is engaged and
ready to operate.
■ Rotate the vacuum bag until the shoulder strap is
upright.
■ Make sure the vacuum bag is zipped and closed
before starting the product.
INSTALLING THE VACUUM TUBES
See fi gure 5 - 6.
WARNING
Rotating impeller blades can cause severe injury.
Always stop the engine and ensure impeller blades
have stopped rotating before opening the vacuum
door or installing/changing tubes. Do not put hands or
any other object into the vacuum tubes while they are
installed on the product.
English (Original instructions)
INSTALLING THE VACUUM TUBES
■ Secure the upper and lower vacuum tubes together
■ Depress door tab using a flathead screwdriver to open
■ Align tabs on housing with the tube assembly.
■ Tighten screws on the upper vacuum tube to secure
REMOVING THE VACUUM TUBES
■ Loosen screws of the upper vacuum tube by turning
■ Remove the vacuum tube assembly from the blower
■ Close the vacuum inlet cover securely. Make sure the
OPERATION
NOTE: The product has positive switches at the blowing
and vacuuming opening sides. The product will only run
if both the metal contacts are inserted into the positive
switches. When running the product in blower mode (Fig.
8), the metal contact on the blower tube and the inlet cover
must be inserted into their respective positive switches.
When running the product in vacuum mode (Fig. 11), the
metal contact on the adapter tube and the vacuum tube
must be inserted into their respective positive switches.
Petrol is extremely fl ammable and explosive. A fi re or
explosion from petrol will burn you and others.
MIXING THE FUEL
■ The product is powered by a 2-stroke engine and
■ The engine is certified to operate on unleaded petrol
■ Do not use any type of pre-mixed petrol/oil from fuel
19
by aligning the raised locking tabs with the matching
orifice on the upper vacuum tube. The two tubes
become one tube assembly after inserting them
together.
the vacuum inlet cover.
to the blower housing. Make sure the metal contact on
the vacuum tube is inserted into the positive switch.
counterclockwise.
housing.
metal contact on the inlet cover is inserted into the
positive switch.
WARNING
requires pre-mixing petrol and 2-stroke oil. Pre-mix
unleaded petrol and 2-stroke engine oil in a clean
container approved for petrol.
intended for automotive use with an octane rating of
91 ([R + M] / 2) or higher.
service stations, this includes the pre-mixed petrol/oil
intended for use in mopeds, motorcycles, etc.