Know Your Product - Ryobi RBV26B Manuel D'utilisation

Allow the engine to run for 10 seconds
before using the product.
To start a cold engine
To start a warm engine
Blower mode
If the quick change lever is pointing on
this symbol, the product operates in blow
mode.
Vacuum mode
If the quick change lever is pointing on
this symbol, the product operates in
vacuum mode
Conforms to all regulatory standards in
the country in the EU where the product
is purchased.
EurAsian conformity mark
Ukrainian mark of conformity
Guaranteed sound power level is 107 dB.
107

KNOW YOUR PRODUCT

See Fig 1a and 1b.
1. Lower vacuum tube
2. Vacuum bag
3. Adaptor
4. Cruise control
5. Throttle trigger
6. Upper vacuum tube
7. Fuel cap
8. Starter grip
9. Choke lever
10. Upper handle
11. On/Off switch
12. Positive switch at blowing side
13. Primer bulb
14. Vacuum handle
15. Upper blower tube
16. Door tab
17. Inlet cover
18. Lower blower tube
19. Positive switch at vacuuming side
20. Raised slot
21. Adaptor installed in vacuum bag
English (Original instructions)
22. Raised locking tab with switch insert metal plate
23. Vacuum bag assembly
24. Vacuum Inlet cover tab
25. Vacuum opening
26. Locking tab
27. Vacuum tube assembly
28. Screw for holding vacuum tube assembly
29. Quick start label
30. High velocity nozzle
31. Air fi lter cover
32. Air fi lter dial - turn to open or close air fi lter
33. Air fi lter
34. Wrench
ASSEMBLY
UNPACKING
This product requires assembly.
■ Carefully remove the product and any accessories
Do not use the product if any parts on the packing list
are already assembled when you fi rst open the box.
The parts on the packing list are not assembled by the
manufacturer and require customer installation. Use of
a product that may have been improperly assembled
could result in serious personal injury.
■ Carefully inspect the product to make sure no
■ Do not discard the packing material until you have
■ If any parts are damaged or missing, please call your
PACKING LIST
■ Blower/vacuum
■ Blower tube
■ Nozzle
■ Upper blower tube
■ Lower blower tube
■ Adaptor installed in vacuum bag
■ Upper vacuum tube
■ Lower vacuum tube
■ Bottle of 2-stroke lubricant
■ Operator's manual
18
from the box. Make sure that all items listed in the
packing list are included.
WARNING
breakage or damage occurred during shipping.
carefully inspected and satisfactorily operated the
product.
Ryobi service centre for assistance.