Cancelling A Washing Programme; Standby Mode; Care And Cleaning; Cleaning The Filters - Zanussi ZDF3020 Notice D'utilisation

Cancelling a washing programme

• Press and hold the start/cancel button.
– In the digital display the time duration of the pro-
gramme flashes.
– One or more phase indicator lights are on.
The washing programme is cancelled.
At this time you can do these steps:
1. Switch off the appliance.
2. Set a new washing programme.
Fill the detergent dispenser with detergent before you
set a new washing programme.
Setting and starting a washing programme with
delay start
1. Set a washing programme.
2. Press the delay start button until the display shows
the necessary delay start time for the washing pro-
gramme. Delay start time flashes in the digital dis-
play.
3. Press the start/cancel button.
– The countdown of the delay start starts.
– The phase indicator lights of the washing pro-
gramme go off.
– In the digital display the delay start time is on with
a static light.
When the countdown is completed, the washing pro-
gramme automatically starts The phase indicator light of
the phase in progress comes on.
Do not open the door during the countdown to pre-
vent interruption of the countdown. When you close

Care and cleaning

Warning! Switch the appliance off before you clean
the filters.

Cleaning the filters

Important! Do not use the appliance without the filters.
Make sure that the installation of the filters is correct.
Incorrect installation will cause unsatisfactory washing
results and damage to the appliance.
62
the door again, the countdown continues from the point
of interruption.
Cancelling a delay start
1. Press and hold the start/cancel button.
– The phase indicator lights or light come on.
– In the digital display, the time duration of the
washing programme comes on.
2. Press the start/cancel button to start the washing
programme.
End of the washing programme
Switch off the appliance in these conditions:
• The appliance stops automatically.
• The digital display shows a zero.
• The phase indicator lights are off.
For better drying results, keep the door ajar for some mi-
nutes before you remove the dishes.
Let the dishes cool down before you remove them from
the appliance. Hot dishes are easily damaged.

Standby mode

If you do not switch off the appliance at the end of the
washing programme, the appliance automatically goes
into standby mode. The standby mode decreases energy
consumption.
Three minutes after the end of the programme, all indi-
cator lights go off and the digital display shows one hor-
izontal bar.
Press a button to go back to the end-of-programme mode.
1 2
Fully clean the filters A, B
and C below running wa-
ter.