Select And Start A Washing Programme; Interrupting A Washing Programme - Zanussi ZDF3020 Notice D'utilisation

Activate or deactivate the multitab function before
the start of a washing programme.
You cannot activate or deactivate the multitab function
when the programme operates. Cancel the washing pro-
gramme, then set the programme again.
To activate the multitab function:
• Press the multitab button. The multitab indicator light
comes on.
To deactivate the multitab function:
• Press the multitab button. The multitab indicator light
goes off.
Do these steps if the drying results are not satis-
factory:
1. Fill the rinse aid dispenser with rinse aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position 2.
• You can only activate or deactivate the rinse aid dis-
penser when the multitab function is activated.
To activate/deactivate the rinse aid dispenser:
The appliance must be switched off.
1. Press and hold the start/cancel button. Turn the pro-
gramme knob counterclockwise until the programme
marker agrees with the first washing programme on
the control panel.

Select and start a washing programme

Do these steps to set and start a washing programme:
1. Close the door.
2. Turn the programme knob to set the washing pro-
gramme. Refer to the chapter 'Washing programmes'.
– The phase indicator light or lights for the washing
programme come on.
– The programme duration in the digital display
flashes.
3. Press the start/cancel button.
– The washing programme starts automatically.
– When the programme starts, only the indicator
light of the phase in progress stays on. Programme
duration is on with a static light.
When the washing programme operates, you cannot
change the programme. Cancel the washing pro-
gramme.
2. Release the start/cancel button when the display
shows the water hardness level.
3. Turn the programme knob counterclockwise until the
programme marker agrees with the second washing
programme on the control panel.
4. The digital display shows the current setting for the
rinse aid dispenser.
5. Press the start/cancel button to change the setting.
The digital display shows the new setting.
6. Turn the programme knob to the off position to save
the operation.
To use normal detergent again:
1. Deactivate the multitab function.
2. Fill the salt container and rinse aid dispenser.
3. Adjust the water hardness setting to the highest level.
4. Do a washing programme without dishes.
5. Adjust the water softener to the water hardness in your
area.
6. Adjust the rinse aid dosage.
Warning! Only interrupt or cancel a washing
programme if necessary.
Caution! Open the door carefully. Hot steam can
come free.

Interrupting a washing programme

Open the door.
• The programme stops.
Close the door.
• The programme continues from the point of interrup-
tion.
Rinse aid dispenser deac-
tivated
Rinse aid dispenser activa-
ted
61