Installing Propeller Adapter, Propeller And Spinner - PARKZONE Extra 300 PNP Manuel D'utilisation

En

Installing Propeller Adapter, Propeller and Spinner

Note: The information on this page is for maintenance of the
Extra 300. Spinner, propeller and propeller adapter damage can
result from aircraft crashes.
CAUTION: DO NOT handle propeller parts while the
flight battery is connected to the ESC. Personal injury
could result.
1. Put collet of propeller adapter (PKZ5102) on the motor shaft
(PKZ5116).
Tip: Some force may be required to fully install the collet on the
motor shaft.
Note: The motor installed in the model may not look the same as the
2. Put the swage plate of the propeller adapter (PKZ5102) on
the collet shaft.
3. Put the spinner backplate (PKZ5107) on the swage plate of
the propeller adapter.
13
motor in photographs.
4. Put the propeller (PKZ5101) on the collet of the propeller
adapter (PKZ5102).
Notice: The propeller (PKZ5101) side with the numbers for
diameter and pitch (for example 10.5 x 9) should face out from
the spinner backplate.
5. Put the hex nut of the propeller adapter (PKZ5102) on the
collet shaft.
6. Tighten the hex nut on the collet to hold the propeller and
propeller adapter on the motor (PKZ5116). A tool may be
required to tighten the nut. (Tool is not included).
7. Make sure spinner (PKZ5107) is fully seated on the spinner
backplate.
8. Install and tighten a screw in the spinner to hold the spinner
on the collet shaft.