Chicco Pocket Meal Mode D'emploi page 14

• Do not place the highchair near
windows or walls where cords, cur-
tains or other objects may be used
by the child to climb out of the
high chair or could represent chok-
ing or strangling hazards.
• Do not place the highchair near
windows or walls also to prevent
your child from afecting the sta-
bility of the highchair by pushing
their feet against the wall and caus-
ing it to topple over.
• Always place the highchair on a
horizontal, stable surface when the
child is seated in it. Never place the
highchair near stairs or steps or on
carpets.
• Bags or weights must not be placed
on the tray or hung on the high
chair frame as they might afect the
stability of the high chair.
• If the highchair is exposed to direct
sunlight for a long time, allow it
to cool down before placing your
child in it.
• Do not leave the highchair in the sun
for a long time: this may alter the col-
our of the materials and fabric.
• Do not use components, replace-
ment parts or accessories that have
not been supplied or approved by
the manufacturer.
• Do not open or close the highchair
when your child is sitting in it.
• WARNING: Do up all 5 buttons
on the frame before using the
highchair.
• When not in use, the highchair
must be kept out of the reach of
children.
COMPONENTS
A. Backrest
B. Seat
C. Armrests
D. Side joint
E. Cover attachment buttons
F. Highchair Frame
G. Rear backrest adjustment lever
H. Carry handle
I. Side release button
J. Cover
K. Safety harness holes
L. Tray
M. Rigid crotch strap
N. Handle for securing the tray
O. Guides for itting the tray
P. Footrest
Q. Legs
R. Safety harness
S. Fabric crotch strap
INSTRUCTIONS
ASSEMBLING/OPENING HIGHCHAIR
WARNING: When performing this operation, ensure that
your child, or other children, are at a safe distance. Make
sure that during these operations the movable parts of the
highchair do not come into contact with your child.
Before using the highchair:
1. Attach legs "Q" to the frame of the highchair as shown
in Figure 1.
WARNING: Do not use the highchair until the legs have
been assembled.
WARNING: The front and back legs are interchangeable
but for best results match the colour of the legs with that of
the structure above.
Assemble the legs by holding down the two locking but-
tons and inserting the legs in the frame. The parts are cor-
rectly assembled only when the two locking buttons come
out from the holes on the legs and an audible click is heard,
signalling that the legs are securely itted.
2. Open the highchair holding the top of backrest "A" and
turn anti-clockwise pulling it upwards until an audible
click is heard, signalling that the high chair is open (Fig.2).
3. After undoing safety harness "R", attach cover "J" to the
frame of highchair "F" passing the safety harnesses
through the dedicated holes (Fig.3).
WARNING: Never use the highchair without its cover.
4. Then attach the cover to the frame using the special but-
tons "E" on the armrests "C" and on the back of the back-
rest (Fig.4-4a).
5. Pass crotch strap "S" through the dedicated hole (Fig.3).
6. Insert footrest "P" in the frame holding down the two
locking buttons on the ends of the footrest and sliding
it into the frame. The parts are correctly assembled only
when the two locking buttons come out from the holes
on the frame and an audible click is heard, signalling that
it is securely itted.
The footrest can be set to two diferent levels in order to
adjust it to the height of your child. To select the desired
height press on the locking buttons at the side, as when
inserting the footrest, and slide the footrest into the desired
position. When releasing, make sure you hear the click, indi-
cating that it is securely in place (Fig.5).
The highchair can now be used by your child.
WARNING: Never move the highchair with your child seat-
14
ed
C
T
I
str
M
W
TIP
Cle
ou
CL
Cle
de
bu
an
Un
the
R
the
Cle
Ne
Ne
I
al
M
K
mo
SA
T
R
P
saf
T
R
in
NA
pa
r
mu
at
W
str
W
y
PO
B
t
W
IM
-
T
Ho
P