Connection And Operation; Fault Symbols - Migatronic FOCUS STICK 161 E PFC Guide De L'utilisateur

Connection and operation

Warning
Read warning notice and
instruction manual carefully
prior to initial operation and
save the information for
later use.
Permissible installation
Mains connection
Connect the machine to the mains supply that it is
designed for (see type plate (U1) on the back of the
machine).
0
l
1
Important!
In order to avoid destruction
of plugs and cables, good
electric contact is required when
connecting earth cables and
welding hoses to the machine.
2
5
6
4
3
1. Mains connection
2. Power switch
3. Connection of earth clamp or electrode holder
4. Connection of earth clamp or electrode holder
5. Welding voltage
The welding voltage indicator is illuminated for
reasons of safety and in order to show if there is
voltage at the output taps or electrode.
Connection of electrode holder for MMA
The electrode holder and earth cable are connected to
plus connection (3) and minus connection (4). Observe
the instructions from the electrode supplier when
selecting polarity.
Switch on, press, weld
• Switch on the welding machine on the main switch
(2)
• Adjust the welding current
• The machine is now ready to weld

Fault symbols

Temperature error
The indicator flashes, when the power source is
overheated.
Leave the machine on until the built-in fan has cooled
it down.
5
2
1