Makita VC1310L Manuel D'instruction page 11

NOTE:
A polyethylene bag available on the
•
market can be used. The 0.04 mm or
thicker one is recommended.
Too much dust will tear the bag easily,
•
so do not collect the dust more than the
half of the bag capacity.
Emptying the polyethylene bag
WARNING:
Always make sure that the cleaner is
•
switched off and unplugged before
emptying the polyethylene bag. Failure
to do so may cause an electric shock
and serious personal injury.
CAUTION:
Do not apply a great impact on the
•
powder filter and tank. Applying a great
impact may cause deformation and
damage to powder filter and tank.
Empty the tank at least once a day
•
although this depends on picked-up
dust volume in the tank. Or, the suction
force will weaken and the motor may be
broken.
Do not grab the hook when emptying
•
the tank. Grabbing the hook may cause
the hook to break.
011600
Unhook and lift up the tank cover.
011602
1. Tank cover
1
2. Polyethylene
bag
2 3. Hook
3
Shake off the dust from powder filter,
damper and prefilter and then take the
polyethylene bag out of the tank.
NOTE:
Take the polyethylene bag carefully out
•
of the tank so that the polyethylene bag
cannot be caught and torn by the
protrusion
emptying it.
Empty the polyethylene bag before it
•
becomes full. Too much dust in the tank
may cause the polyethylene bag to be
torn.
Installing powder filter
6
1. Tank cover
2. Powder filter
3. Damper
4. Prefilter
5. Tank
6. Mounting position marking
011637
Place the prefilter in the tank.
Next, mount the damper on the powder filter
and then place it in the prefilter.
When installing powder filter and prefilter,
the mounting position marking on each of
them are aligned with that one at the top of
the tank.
Finally, mount the tank cover.
11
inside the tank when
1
2
3
4
5