Replacing The Brick; Maintenance And Cleaning; Disposal - Parkside PBSG 95 D5 Instructions D'utilisation Et Consignes De Sécurité

1 2
180
Set the ON / OFF switch
"0" to switch off the product.

Replacing the brick

RISK OF INJURY!
Always unplug from the mains before
working on the product. Replace a worn
or damaged brick (diminished, uneven
grinding, broken brick). You will need a
cross-tip screwdriver for this step.
Unscrew the 4 screws
cover and remove the cover
2
(see Fig. A).
Remove the brick
Loosen the screw connection
ing the brick
5
with a 27 mm open-end spanner (not in-
cluded) or a nut driver (see Fig. B).
Note: Turn counter-clockwise to open!
Remove the metal ring
Secure the new brick in the brick holder
with the flattened edge down and
8
reinstall the metal ring
Tighten the screw connection with a
27 mm open-end spanner.
Note: Turn clockwise to close!
Be sure the spring
product as shown in Fig. D and insert
the brick into the product. Turn the brick
until it is again precisely fitted as shown
in Fig. A or the brick cover
20 GB/IE
(b) (b)
3
(a)
0
α =
118 0
to position
4
on the brick
3
2
.
5
keep-
7
in the brick holder
.
6
.
6
is installed in the
9
will not fit.
2
Reattach the brick cover
in place with the 4 screws

Maintenance and cleaning

This product is maintenance-free except for
replacing the bricks.
the socket prior to performing mainte-
nance or repairs.
Clean the product regularly, preferably
immediately after every use.
Use a dry cloth to clean the housing.
Never use petrol, solvents or cleaning
agents that attack plastic.
Never open the product except to replace
the brick. Always have repairs or parts
replacements performed at the service
centre or by an electrician. If the input
lead on this product is damaged, it must
8
be replaced with a specially prepared
power cord at the service centre.

Disposal

The packaging is made entirely of recyclable
materials, which you may dispose of at local
recycling facilities.
Observe the marking of the
packaging materials for waste
b
a
separation, which are marked
with abbreviations (a) and num-
bers (b) with following meaning:
and fasten
2
.
3
RISK
OF ELECTRIC SHOCK!
Unplug the mains plug from
RISK OF INJURY!