_______________________________________________________________
7.4 Maintenance work
Only authorised and qualified personnel may carry
out maintenance work. For more information, please
contact our Customer Service Department. (see
Service
).
Before adjusting the height of the desk, make sure
that the desktop is level. If the floor is uneven, align
the desktop with the adjusting screws on the feet.
Ensure that there are no objects in the movement
range of the lift column!
Danger due to voltage!
Contact with voltage can cause
severe injury or death by electric
shock!
Attach or detach
connectors only when the
equipment is de-
energised.
Do not open the housings
of the following
components:
- Controller
- Columns
- Operating panel
Risk of injury!
Unintentional lifting or lowering of the
desktop may cause injury.
For maintenance work on all non-
electrical components of the desk,
detach the electrical connection of the
height adjustment from the mains
supply.
24
Risk of injury or damage!
When lifting on the desktop or
9
attached components, the fastening
screws may tear.
ATTENTION
Risk of damage to lift mechanism!
The values saved in the controller do not
match the values for another desk.
After disassembling the desk, for example for
transport reasons:
Always reattach the two side
frames to the associated
desktop cross-member of the
same desk.
Comply with the separate
assembly instructions in this
regard.
ATTENTION
Using unapproved spare parts may
cause damage to the desk.
Only components provided by Steelcase
may be used as spare parts. Coordinate
the installation of differing parts with
Steelcase.
Observe specified maintenance
and inspection intervals.
7.4.1 Disclaimer of liability
Steelcase assumes no liability or warranty in the
following cases (see
■
Inadequate monitoring of the product
components (functional checks).
■
Improper maintenance.
■
Maintenance by a third party.
■
Maintenance by unqualified and unauthorised
personnel.
■
Use of components and adaptations that do not
originate from Steelcase.
Always take hold of the desk at the
underframe to transport or move it.
Liability, Page 2
Maintenance
):
120917