Crank Variant; Variants Lift; Operating Panel - Steelcase Ology Manuel D'utilisation

Masquer les pouces Voir aussi pour Ology:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 59
_______________________________________________________________
Figure 5-1: Adjusting the desk height, Telescopic variant
1
Display – desk height
2
Adjustment wheel
2
Maximum desk height
4
Average desk height
 Remove all objects from the desk.
 Loosen the adjustment wheel.
 Pull up or slide down the telescopic column by
the desired length (see scale).
 Hold the desktop while doing so!
 Do not stand under the desk while adjusting the
height!
 Tighten the adjustment wheel.
 Adjust all columns to the same height.
Crank
5.2.3
variant
The desk can be variably adjusted to a height
between 620 mm and 900 mm.
Figure 5-2: Ology Crank, adjusting the desk height
1
Crank in park position
2
Crank in working position
2
Maximum desk height
4
Average desk height
120917
Operating and adjusting
 Remove all objects from the desk.
 Pull the crank out of the parking position.
Crank the telescopic columns up or down by
the desired height (see scale).
All columns are moved simultaneously.
Do not lift the desktop during cranking.
 Push the crank back into the parking position. If
the crank remains in its working position, there is
danger of impact!
Lift 1
5.2.4 Variants
The desk can be variably set at a height between 720
mm and 1200 mm (variant - Lift 1) or between 650
mm and 1250 mm (variant - Lift 2).
Make sure before first use that
the desk has been assembled correctly;
the controller is connected to the motor by cable;
the operating panel is connected to the
controller;
all safety instructions have been followed.
For the power connection
 Insert the mains plug into a power point supply-
ing 220/230 V.
Prior to placing the desk in service it is
necessary to perform a manual reset.
The instructions for this procedure can be
found in the description of the
corresponding control panel.

5.2.5 Operating panel

Simple Touch
operating panel
The operating panel is located on the left or right on
the underside of the desktop.
Figure 5-3: Simple Touch operating panel buttons
Lift 2
and
13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ology bench

Table des Matières