Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
®
Personal Work Surface
Replacement with Covers
1.
Press inward on bottom edge of
screw cover to disengage hooks (1a)
and rotate outward to remove (1b).
2.
Using a T40 torx bit, remove the
six screws that retain the personal
work surface.
3.
Slide the arm bayonet out from the
personal worksurface.
4.
Reverse steps 1 thru 3 to install
new personal worksurface.
NOTE: None of the latch pins should
not be exposed once cover is installed.
1a
WORKSURFACE
3
BAYONET
1b
SCREW
2
1025192001 Rev C
Page 11 of 87
Publicité
Table des Matières
