EUROM GOLDEN 2000 ULTRA Mode D'emploi page 16

hanging bracket (9) between both holes as indicated on the diagram. Push the pin with
the second screw back through the holes and the hanging bracket. Then place the first
Allen screw back and turn to secure using the Allen key.
The EUROM GOLDEN 2000 ULTRA (RCD) c.q. 2500 Ultra RCD can be installed in three
ways:
 Suspension from a wall (or possibly ceiling) by means of a wall bracket
 Suspension from a frame (parasol, tent or similar item) by means of a bracket
 Suspension from a ceiling by means of chains
Remove all package material (including the shock absorbing material around the bulb)
before installating the heater and check the appliance, supply cord and the plug for signs
of damage.
Carefully choose the right place to install your heater.
Before fastening, check that the minimum safe distances between the surroundings and
the chosen location are respected:
Minimum distance lowest point of heater – floor: 1,8 metres
Minimum distance heater – heated object: 1 metre
Minimum distance top* heater – fire-resistant ceiling: 0.2 metres
Minimum distance top* heater – tent tarpaulin, parasol etc.: 0.25 metres
Minimum distance side heater – walls, obstacles, objects: 0.5 metres
* The top of the heater is the side where the suspension bracket is attached.
If you suspend the device outside, ensure that it is protected from the wind.
1 – Suspension from a wall (or possibly ceiling) by means of the wall bracket
 The appliance has to be mounted preferably on an incombustible foundation. That
foundation has to be vibrationfree, exact vertical and stable enough for lastingly
holding the appliance free of problems. Check or the provided dowels and screws are
suitable, strong enough and qualified for the
foundation. The material provided is identified for a
brick wall; for another foundation please ask the
specialist for suitable material.
 Fix the mounting bracket totally horizontal on the
wall with the four anchor dowels provided see fig.
16
 Hang
the
terrace heater
with the
suspension bracket in the wall bracket. Refer to
the picture. Slide the bracket through the wall
bracket as far as possible – the small hole in the
bracket protrudes under the wall bracket. Secure
that terrace heater by screwing the short wing
nut supplied as far as possible into the small hole
in the suspension bracket.