Technical Data; Safety Instructions; Basic Information Concerning Safety; Personal Safety - Hilti DX 36 Mode D'emploi

Standard accessories
Designation
36/F3 fastener guide
36/S13 base plate
36/DNI piston
Spring clip

4. Technical data

Right of technical changes reserved.
Tool
Weight
Dimensions (L x W x H)
Maximum fastener length
Cartridges
Power regulation
Contact movement
Contact pressure
Ambient operating temperature range
Recommended maximum fastening rate

5. Safety instructions

5.1 Basic information concerning safety

In addition to the information relevant to safety
given in each of the sections of these operating
instructions, the following points must be strictly
observed at all times.
5.1.1 Requirements to be met by users
a) The tool is intended for professional use.
b) The tool may be operated, serviced and re-
paired only by authorized, trained personnel.
This personnel must be informed of any special
hazards that may be encountered.

5.1.2 Personal safety

a) Stay alert, watch what you are doing and use
common sense when operating a direct fasten-
ing tool. Don't use the tool when you are tired or
under the influence of drugs, alcohol or medic-
ation. Stop using the tool if you experience pain
or do not feel well. A moment of inattention while
Printed: 07.07.2013 | Doc-Nr: PUB / 5069831 / 000 / 00
Item number
3737
3738
409313
3739
DX 36
2.4 kg
370 mm × 52 mm × 151 mm
62 mm
6.8/11 M (27 cal. short) green, yellow, red
3 cartridge power levels, power regulation wheel
14 mm
140 N
-15...+50°C
600/h
operating the tool may result in serious personal
injury.
b) Avoid unfavorable body positions. Make sure
you work from a safe stance and stay in balance
at all times.
c) Wear non-skid shoes.
d) Never point the tool toward yourself or other
persons.
e) Never press the nosepiece of the tool against
your hand or against any other part of your body
(or other person's hand or part of their body).
f) Keep other persons, especially children, away
from the area in which the work is being carried
out.
g) Keep the arms slightly bent while operating the
tool (do not straighten the arms).
h) Observe the information printed in the operat-
ing instructions concerning operation, care and
maintenance.
en
23