Technical Data - Hilti BX 3-SCT Mode D'emploi

4

Technical data

4.1 Fastening tool
Weight in accordance with EPTA Procedure 01
including battery B22⁄2.6
Fastener guide
Fasteners
Length, fastener
Fastener diameter
Compression stroke
Contact pressure
Application temperature (ambient temperature)
Application temperature, fastener
Recommended maximum driving rate
Rated voltage
Frequency
Maximum emitted transmission power
4.2 Battery
Battery operating voltage
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
4.3 Noise information and vibration values
The sound pressure and vibration values given in these instructions have been measured in accordance
with a standardized test and may be used to compare one power tool with another. They may be used
for a preliminary assessment of exposure. The data given represents the main applications of the power
tool. However, if the power tool is used for different applications, with different accessories or is poorly
maintained, the data may vary. This may significantly increase exposure over the total working period. An
accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This may significantly reduce exposure over the total
working period. Set out additional safety measures to protect the operator from the effects of noise and/or
vibration, such as: Maintaining the power tool and accessories, keeping the hands warm, reorganization of
work patterns.
Noise and vibration information (measured in accordance with EN 60745-2­16)
Typical A-weighted sound power level, L
crete)
Typical A­weighted emission sound pressure level, L
into concrete)
Uncertainty for the specified sound levels, K
Total uniaxial vibration values (in z-direction)
Vibration emission value (driving studs into concrete) with B22 2.6 bat-
tery (a )
h
Uncertainty, K
*2338836*
4.0 kg
X­FG B3­SCT 02
•
•
•
52 mm / 62 mm / 87 mm
6 mm
12 mm
50 N ... 70 N
−15 ℃ ... 50 ℃
−10 ℃ ... 50 ℃
650/h
21.6 V
2,400 MHz ... 2,483.5 MHz
−11.9 dBm
(driving studs into con-
WA
pA
2338836
X­M6­8­52 DP7 SCT B3
X­M6­8­62 DP7 SCT B3
X­M6­8­87 DP7 SCT B3
21.6 V
−17 ℃ ... 60 ℃
−20 ℃ ... 40 ℃
−10 ℃ ... 45 ℃
96 dB
(driving studs 85 dB
3 dB
6.3 m/s²
1.5 m/s²
English 19