Operation - Hilti DX 36 Mode D'emploi
Masquer les pouces
Voir aussi pour DX 36:
- Mode d'emploi (23 pages) ,
- Mode d'emploi (73 pages) ,
- Mode d'emploi (19 pages)
Table des Matières
Publicité
7.1.1 Minimum distances and spacing
Minimum distances and spacing when fastening to steel
en
Minimum distances and spacing when fastening to concrete
7.1.2 Depth of penetration
NOTE
Examples and specific information can be found in the Hilti Fastening Technology Manual.
Nail lengths for steel
ET
Nail lengths for concrete
ET
8. Operation
WARNING
The material may splinter or fragments of the
magazine strip may fly off when the fastener is
26
Printed: 07.07.2013 | Doc-Nr: PUB / 5069831 / 000 / 00
A
min. edge distance = 15 mm ( ")
B
min. spacing = 20 mm ( ")
C
min. base material thickness = 4 mm (
A
min. edge distance = 70 mm (2 ")
b
min. spacing = 80 mm (3 ")
c
min. base material thickness = 100 mm (4")
ET Depth of penetration: 12 ± 2 mm (½" ±
ET Depth of penetration: 22 mm (max. 27 mm)
( " (max. 1"))
driven. The user of the tool and all persons in the
vicinity must wear eye protection and a hard hat.
Splintering material presents a risk of injury to the
eyes and body.
")
")
Publicité
Chapitres
Table des Matières
Dépannage
