Description - Hilti DX 36 Mode D'emploi

1.2 Explanation of the pictograms and other
information
Warning signs
en
General Warning:
warning explosive
substances
Obligation signs
Wear eye Wear a hard
protection
Symbols
Read the
operating
instructions
before use

2. Description

2.1 Use of the product as directed
The tool is designed for professional use in fastening applications where nails, threaded studs and composite
fasteners are driven into concrete, steel and sand-lime block masonry.
The tool is for hand-held use only.
Modification of the tool is not permissible.
The tool may not be used in an explosive or flammable atmosphere unless it has been approved for use under
these conditions.
To avoid the risk of injury use only genuine Hilti fasteners, cartridges, accessories and spare parts or those of
equivalent quality.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
The tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or
when used not as directed.
The tool may be operated, serviced and repaired only by trained personnel. This personnel must be informed
of any special hazards that may be encountered.
As with all powder-actuated fastening tools, the tool, cartridges and fasteners form a technical unit. This
means that trouble-free fastening with this system can be assured only if the Hilti fasteners and cartridges
specially manufactured for it, or products of equivalent quality, are used. The fastening and application
recommendations given by Hilti apply only when these conditions are observed.
For optimum results and maximum reliability we recommend use of Hilti cartridges or products of equivalent
quality.
20
Printed: 07.07.2013 | Doc-Nr: PUB / 5069831 / 000 / 00
Warning: hot
surface
Wear ear
hat protection
Location of identification data on the tool
The type designation and serial number can be found
on the type identification plate on the tool. Make a
note of this data in your operating instructions and
always refer to it when making an enquiry to your
Hilti representative or service department.
Type:
Generation: 01
Serial no.: