Disposal; Manufacturer's Warranty - Tools - Hilti DX 36 Mode D'emploi

Fault
Nail breakage.
en
The head of the nail punches
through the material fastened
(sheet metal).

11. Disposal

Most of the materials from which Hilti tools or appliances are manufactured can be recycled. The materials must
be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements
for taking back old tools and appliances for recycling. Ask Hilti customer service or your Hilti representative
for further information.

12. Manufacturer's warranty - tools

Hilti warrants that the tool supplied is free of defects
in material and workmanship. This warranty is valid
so long as the tool is operated and handled correctly,
cleaned and serviced properly and in accordance with
the Hilti Operating Instructions, and the technical
system is maintained. This means that only original
Hilti consumables, components and spare parts, or
other products of equivalent quality, may be used in
the tool.
34
Printed: 07.07.2013 | Doc-Nr: PUB / 5069831 / 000 / 00
Possible cause
Driving power is too low.
Application limit exceeded (very
hard material).
Driving power is too high.
This warranty provides the free-of-charge repair or
replacement of defective parts only over the entire
lifespan of the tool. Parts requiring repair or replace-
ment as a result of normal wear and tear are not
covered by this warranty.
Additional claims are excluded, unless stringent na-
tional rules prohibit such exclusion. In particular,
Hilti is not obligated for direct, indirect, incidental
Remedy
Increase driving power (adjust
power regulating wheel).
Use a more powerful cartridge.
Use a shorter nail.
Use a nail with a higher application
limit.
Reduce driving power (adjust the
power regulating wheel)
Use a less powerful cartridge.
Use a nail with a "top hat".
Use a nail with a washer.