Attention; Troubleshooting - Elite Cube Digital Notice D'utilisation

EN
• During use of the Cube Digital with Elastogel
roller, slight wear of the roller is quite normal.
Tests carried out at Elite show that after conti-
nuous use for 20,000 km, roller wear is around 0.1
mm, and since the total thickness is 10 mm, cor-
rect operation of the trainer will not be affected
even with far greater wear. Claims that are due to
improper or careless use, will not be acknowled-
ged. Slight wear of the part in rubber is quite
normal.
• Using the Cube Digital with narrow tyres or with
unsuitable tyre pressures can permanently dama-
ge the Elastogel roller.
• The console to be fitted on the handlebar is not
waterproof. Make sure sweat does not come into
contact with it, as this could damage the electro-
nic circuit.
• Do not store the Cube Digital in wet or damp
places. The electronic components could become
damaged.
• The Cube Digital may not comply with the EC
directives if the power adapter supplied (ref. G) is
not used.
• If slipping of the wheel on the Elastogel roller is
noticed, apply a more gradual force on the pedal.
Training with the tyre slipping can permanently
damage the Elastogel roller.

TROUBLESHOOTING

Disconnections
• In case of disconnection during the training ses-
sion, wait until the speed value indicated is "-.-".
Then keep the right button of the cycle computer
pressed for three seconds. This will restart the
receiver module and the connection should be
restored.
• If the heart-rate is not displayed, press the right
button of the cycle computer for three seconds.
This will restart the receiver module and the data
28

ATTENTION

should be displayed again.
• If connection is unsuccessful, try doing the pro-
cedure for coupling between the cycle computer
and the resistance unit again.
Heart-rate not displayed
Try doing the procedure for coupling between the
cycle computer and the chest band again.
Error AP2
If the message "AP2 error" appears on the screen,
it means that the communication between the
resistance unit and the cycle computer has failed.
Wait a few minutes, and the cycle computer will
try to reconnect the two parts. If the problem per-
sists, do a hardware reset by pressing the AC
button.
Delay in power variation
From the moment the power is varied, there may
be a few seconds delay before the unit delivers the
required power. This is due to the inherent struc-
ture of the resistance unit and should not be con-
sidered a defect in the unit.
Battery change
If the computer does not work correctly after
changing the battery, it is advisable to press the
AC button (located on the back of the computer)
with a sharp object.