Characteristics And Functions; Initial Setup Procedure; Buttons - Elite Cube Digital Notice D'utilisation

• Fit the computer (ref. B) on the support, by
sliding from above.
• Make sure the computer is fixed securely to the
handlebar.
• To release the computer from the support, press
the support tab and slide the computer backward.
Warning: the indoor trainer will work properly only
if the console (ref. B) is completely plugged into the
bracket (ref. C) and the power charger (ref. G) is
plugged into an electrical outlet and the connector
into the resistance unit.

CHARACTERISTICS AND FUNCTIONS

The cycle computer enables various training
methods to be carried out and adapted to the
needs of each athlete. The rider can display his
own current data (speed, power, cadence, heart-
rate) at any time, and also the average and maxi-
mum values. There are also special functions,
such as the heart-rate training zones, for optimi-
sing training.
Three different training modes are available:
- Power Mode (POWER): in this mode it is possi-
ble to train by setting the required power (from
60 to 990 watt); the roller will automatically
adjust the resistance to maintain the set power.
The required power can be varied at any time.
- Level Mode (LEVEL): in this mode it is possible
to train by selecting the required level (16 diffe-
rent levels). This enables the simulation of a
situation comparable to that experienced on the
road, therefore the power generated will depend
on the speed being maintained. The roller's resi-
stance level can be varied at any time.
- Program Mode (PROGRAM): in this mode it is
possible to choose from ten different training
programs during which the roller will automati-
cally adjust the power. The rider can vary the
program's difficulty level at any time, adapting it
to his own athletic ability.
A very intuitive main menu allows the various
functions of the cycle computer to be displayed.
5
Once the mode or the required function is displa-
yed, just press the middle button to activate it.
From any point in the program, a long press (3
seconds) of the middle button will bring up the
main menu.
The functions and the training modes are explai-
ned in detail in the following sections of this
manual.

INITIAL SETUP PROCEDURE

For correct use, at first startup it is necessary
to enter the correct settings for the training.
Therefore, once the battery is inserted, the
cycle computer will do a test of the segments,
which is quitted by pressing any button, and
then directly begin the SETUP phase.
A more detailed explanation on how to modify
these values and regarding their meaning is
given in the SETUP section of this manual.
Note: These settings can modified at any time
by accessing the SETUP function from the main
menu.
The cycle computer uses the following buttons:
- middle button: press to confirm a value (SETUP)
or start the selected training session, and to chan-
ge screen during a training.
Press the middle button for about 3 seconds (long
press) to return to the main menu from any screen.

BUTTONS

EN
21