Electrode Welding - GYS Easymig 130 Mode D'emploi

Translation of the original instructions
GASLESS WIRE WELDING
The Easymig can weld gasless wire up to 0.9mm, if the polarity is reversed (fig III / p.75) respecting a maximum
pressure of 5Nm. For parameters of use, please refer to the instructions indicated on page 2. Welding gasless
wire with a standard nozzle can lead to overheating and deterioration of the torch. It is recommended to use a
"No Gas" nozzle (ref. 041868), or remove the genuine nozzle (Fig. III / p.75).

ELECTRODE WELDING

• The reverse polarity cable must be disconnected in MMA (stick welding) mode in order to connect the electrode
holder and earth clamp. Connect the electrode holder and earth clamp as indicated on the electrode packaging.
• Respect the basic rules of welding.
• This device has 1 feature specific to Inverter machines :
- Anti-Sticking: Enables easy removal of the electrode from the metal. The anti-sticking feature, after its start,
requires approximately a 3 seconds delay before resuming normal welding operations.
SETTINGS PANEL (FIG V)
• Green light «ON»: when the machine is switched on the light
turns on.
1
• In case of power failure, the green light goes off but the device
remains powered while the power cable is unplugged.
• Orange light :
• Over-temperature: in such a case you shall wait a few minutes,
2
the light will turn off and the machine will start again.
• Over-current on primary circuit: in such a case you shall switch
off the machine (with the main switch) and switch on.
• Left button:
- MIG / MAG Welding : Adjust the wire feeder speed up to
maximum speed.
3
- MMA welding : Adjust the welding current.
• Right button:
- Adjust the voltage reference up to the maximum value.
4
Advices
The wire speed adjustment is often determined « by the noise »: the arc must be stable and have a low
crackling.
If the speed is too low, the arc is not continuous.
If the speed is too high, the arc crackles and the wire pushes back the torch.
PROCESS OF REELS AND TORCHES ASSEMBLY (FIG IV /
• Remove the contact tube and its support (fig D), and the nozzle (fig E) from the torch.
Fig A : • Position the wire reel on the reel support :
• Adjust the reel brake (1) to avoid reel movement tangling the wire when welding stops. Be careful not to tighten
too much.
Easymig 150 : For a 200mm wire reel tighten the reel to the maximum. The adaptor (4) is only to be used for a
200mm reel.
18
EASYMIG 130 / 140 / 150
.75):
p
EN