Technical Specifications - Velleman VTDESOL3 Mode D'emploi

4. Operation
1. Plug the power cord into a power source.
2. Allow the nozzle to warm up for approx. 5 min.
3. Press the plunger [1] until you hear a clicking sound.
4. Place the tip of the nozzle against the solder you wish to remove.
5. When the solder melts, press the button [2] on the handle and
the solder will be absorbed.
5. Cleaning and nozzle replacement
1. Turn off the power and wait until the unit has
completely cooled before removing the solder
waste or replacing the nozzle.
2. To clean the unit, push [1] the plunger slightly in
the direction of the button and remove it from the
grip [2].
3. Remove the solder waste around the tip and inside
the plunger.
4. To replace the nozzle, turn it anticlockwise with a
pair of pliers and remove from the handle.
6.

Technical Specifications

inner Ø of tip ....................................................................................................... 1.8 mm
power supply .............................................................................................. 230 V~, 50 Hz
power ..................................................................................................................... 30 W
Use this device with original accessories only. Velleman nv cannot be held responsible in the event
of damage or injury resulting from (incorrect) use of this device. For more info concerning this
product and the latest version of this manual, please visit our website www.velleman.eu. The
information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part of this
manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the
prior written consent of the copyright holder.
V. 03 – 25/04/2018
VTDESOL3
3 ©Velleman nv