Technical Specifications - Velleman VTSSC78 Mode D'emploi

10.3 Common Causes for Tip Failure
The temperature of the tip exceeds 410° C (770° F).
•
The tip is not sufficiently tinned.
•
Wiping the tip on a surface with a high sulphur content or on a dirty or dry sponge.
•
Contact with organic or chemical substances such as plastic, resin, silicone and grease.
•
Impurities in the solder and/or a low tin content.
•
10.4 Fuse Replacement
Refer to the illustrations on page 2 of this manual.
1. Switch off the soldering station [5] and unplug it from the mains.
2. Release the screw at the back of the station [X] and lift the top cover.
3. Locate the fuse [F] and replace it. Only replace the fuse by a fuse of the same type and rating.
4. Close the top cover and put the screw [X] back.
11.

Technical Specifications

max. heater power for soldering iron ................................................................ 80 W
temperature range ............................................................. 150F480 °C (302F896 °F)
iron voltage ..........................................................................................220F240 V~
weight ..........................................................................................................770 g
dimensions .................................................................................. 105 x 90 x 85 mm
Use this device with original accessories only. Velleman nv cannot be held responsible in the
event of damage or injury resulting from (incorrect) use of this device. For more info
concerning this product and the latest version of this manual, please visit our website
www.velleman.eu. The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part
of this manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise
without the prior written consent of the copyright holder.
V. 01 – 12/04/2016
VTSSC78
8 ©Velleman nv