Charging The Battery; Charging Status Indication - FujiFilm instax Square SQ 20 Guide D'installation

Charging the Battery

Be careful of the orientation.
Connect the camera to a smartphone power adapter using
the supplied USB cable to an indoor power outlet.
• Use a USB AC adapter to meet the rated output below:
DC 5.0 V/1000 mA
• You can take a picture or print an image while
charging is in progress.
• Charging time is approximately two to three hours.

Charging status indication

While camera
Status
is on
->
The (
->
) icon
While
appears on the lower
charging
right of the LCD
monitor.
The ( ) icon
appears on the lower
Charging
right of the LCD
finished
monitor. (Goes off
when disconnecting
the USB cable.)
An error message
Charging
appears on the LCD
error
monitor.
Charging from a PC:
• Connect the camera and PC directly. Do not connect
• If the PC enters the sleep mode while charging is in
• You may not be able to charge the camera from a PC
Caution
• You cannot remove the battery from the camera.
• The battery is not charged fully at shipment. Be sure to
• Read the cautions in "The battery". (Page 40)
While camera
is off
Self timer lamp lights
up.
Self timer lamp goes
off. (The USB cable is
connected.)
Self timer lamp
flashes.
them via a keyboard or USB hub.
progress, charging will stop. If you continue charging,
resume the PC and reconnect the USB cable.
depending on your PC specifications, settings, or status.
charge it before using the camera.
EN
9